How to install a dishwasher

Location selection


The machine should not interfere with the owner during her classes in the kitchen, as well as family members, guests during the meal. At the same time, place the unit as close as possible to the sink. The floor must be flat so that the machine does not have any distortions in any plane. To check this, shake the machine and make sure that there are no backlashes (if necessary, use the building level). If this rule is not followed, then the unit is inevitably shaken and, as a result, it will soon fail. Pay attention to the power supply: the unit requires a separate grounded outlet. If it is not there, then it is necessary to conduct electrical wiring to the location of the dishwasher in advance. It is also necessary to calculate the distance to the sewage system: the length of the drain hose of the unit should not exceed 1.5 m; otherwise, the pump motor will work with overload, which will lead to its premature failure.

Dishwasher connection


To connect to the plumbing and sewer it is desirable to use the hoses that come with the kit. If the input does not have a common water filter, then it must be installed at least in front of the unit. After the filter you need to install a stopcock. Some models have a hot water connection, but if you use a separate water heater at home (in the country), then it is better to connect the machine to cold water, because in this case, water heating will be cheaper. Drainage (drain) is usually connected to the sink through a tee; it is important to withstand the slope of the hose so that dirty water does not go back to the sink.
The connection of electricity usually does not cause problems, but it should be remembered that the electric motors used in the unit, including the pump. have a large enough power; therefore, the power supply cable, socket must be designed for the corresponding current consumption. It does not recommend the use of tees, extension cords - only a separate outlet is needed. An even better option is to connect directly to an electrical panel; in this case, a 16 amp circuit breaker is required.
After all connections have been completed, the unit must be tested in test mode. To do this, start the machine without dishes, but with detergent. Check how the water is poured, how it is heated, how it is drained and dried. Do not lose sight of the tightness of the connected pipes and hoses. Making sure that everything is normal, you can push the unit into place and use the "benefits of civilization."

Date: 08.10.2018, 19:05 / Views: 65544

Related News


Simple Ribbon Roses
Update car drives
Take a different tile and in no time update the kitchen interior
A modern bedroom for a bachelor
Ultrasonic Washer
Honey Pancakes
A cozy place to read and store books
5 reasons why a woman becomes more beautiful with age